Connecting a DVD-RW SATA IDE internal tape for

SATA is the standard interface for hard drives and optical adaptador molex Most modern motherboards with at least two outlets SATA available. But the old equipment, built before 2003, when it was first released SATA instead provide one fifty-nine IDE sockets. The storage devices are connected to an IDE plug through a 40-pin ribbon cable.
To upgrade the optical drive on a computer that does not have SATA sockets, connect a SATA-to-IDE adaptador molex IDE to SATA converter to one of the IDE slots on the board and then connect the unit to the DVD-RW drive.

Things You’ll Need

adaptador molex Converter SATA-to-IDE IDE to SATA

Phillips screwdriver

Wrist Strap


Turn off the computer, unplug the power cord connected to the PC and then press the power button on the front of the box to drain the motherboard of electric charge.

Loosen the screws and press the lever up or cover computer case. Remove the lid of the box.

Touch the metal part of the computer case, or put on an antistatic wrist strap, to ground.

Connect one end of a SATA data cable to the drive and then connect the other end of the cable to the DVD-RW.

Plug the floppy drive in the 4-pin plug in the drive and then insert the plug on the other end of the cable into a Molex adapter connected to the power supply.

Insert the 40-pin connector on the drive to the IDE ribbon slot motherboard.

Tips adaptador molex Warnings

Depending on the make and model of the converter, you may need to connect a Molex adapter directly to the converter, unlike a cable from the floppy drive.

adaptador molex devices, adaptador molex drives and optical, adaptador molex motherboards, adaptador molex outlets, adaptador molex screws and press, adaptador molex sockets, connected adaptador molex to an, released adaptador molex